BRAYER BR4150, Instruction Manual

Page: 11 / 48

11 EN
1. Make sure that the power plug (10) is not inserted
into the mains socket.
2. Grasp the lid (3) and open the filling hole of the water
tank (2) (Fig. 3) fill the tank (2) to the maximum water
level «МАХ».
Note: do not pour vinegar or any other descaling agents
into the tank (2).
3. Set the temperature control knob (9) to the position.
4. Connect the power plug (13) into a mains socket,
press the on/off button (12), the iron will switch on and
the light indicator (7) will flash. When the iron soleplate
(6) reaches the set temperature, the indicator (7) will
glow constantly.
5. Place the iron horizontally over the sink, press and
hold the steam supply button (8) « », and the sound of
the running pump will be heard.
6. After 45-60 seconds, release the steam supply
button « » (8), set the temperature controller (9) to
the «••» position and wait for the bottom of the iron to
heat up (6). Repeat the cleaning process described in
paragraph «5».
7. After 45-60 seconds, release the steam supply
button « » (8), set the temperature controller (9) to
the «Max» position and wait for the bottom of the iron to
heat up (6). Repeat the cleaning process described in
paragraph «5».
8. Turn off the device by pressing the on/off button
(12) and unplug the power cord (13) from the electrical
outlet, wait for the iron to cool down.
CLEANING AND MAINTENANCE
• Before cleaning the steam station make sure that it is
switched off and the iron is cold and the power plug
is not connected to the mains socket.
• Wipe the steam station body (1) and the iron with a
slightly damp cloth, and then wipe them dry.
• You can remove the mineral deposit from the iron
soleplate (6) with a cloth soaked in table vinegar.
• Do not use abrasives or solvents to clean the steam
station body (1), the iron body and the soleplate (6).
• Avoid contact of the iron soleplate (6) with sharp
metal objects, as well as with metal buttons, zippers
etc.
• Do not immerse the steam station body (1), the iron,
the power cord and the power plug (13) into water or
any other liquids.
STORAGE
• Before taking the steam station away for storage
drain the remaining water from the water tank (2) and
clean the steam station body (1) and the iron.
• Set the temperature control knob (9) to the position
«MIN».
• Install the iron on the body of the steam station (1)
and press the latch (4) (Fig. 2).