7
EN
• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or
similar qualified personnel to avoid danger.
• Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any malfunction
is detected, and after the unit was dropped, unplug it
and apply to the service center.
• To avoid damages, transport the unit in the original
package.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using.
• Unpack the steam station and remove any packaging
materials and advertising stickers.
•
If there is a protective film on the soleplate (6),
remove it.
• There may be water residue in the tank (2), as the
steam station has undergone factory quality control.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
•
Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. When using the unit in
the mains with 60 Hz frequency, the unit does not
need any additional settings.
• Remove the iron from the body of the steam station
(1), to do this, unlock the latch (4) (Fig. 1) and
remove the iron.
• Clean the steam station body (1) and the iron
soleplate (56) with a slightly damp cloth, then wipe
it dry.
WATER SELECTION
•
Use tap water to fill the water tank (2).
•
We recommend to fill the tank (2) with water
additionaly cleaned with domestic filters.
• If tap water is hard, it is recommended to mix it with
distilled water in proportion 1:1. If tap water is too
hard, mix it with distilled water in proportion 1:2 or
use distilled water only.
FILLING THE WATER TANK
ATTENTION!
Before filling the water tank (2) with water
make sure that the iron is switched off and unplugged.
•
Grasp the lid (3) and open the filling hole of the water
tank (2) (Fig. 3).
Summary of Contents for BR4150
