BRAYER BR4150, Instruction Manual

Page: 9 / 48

9 EN
steam station on an ironing board, make sure that the
ironing board is secure and stable.
• Steam ironing is possible only if the temperature
control knob (7) is set to the steam mode «•••» ,
«MAX».
• Switch the iron on by pressing the on/off button (12),
the iron will switch on and the light indicator (7) will
start flashing.
• Place the iron on the steam station body (1) in the
iron installation place (4).
• Insert the power plug (10) into a mains socket.
• Make sure that there is enough water in the water
tank (2).
• Turn the knob (7) to set the required ironing
temperature in the steam operation zone «•••»,
«MAX».
• Switch the iron on by pressing the on/off button (12),
the iron will switch on and the light indicator (7) will
start flashing.
• Once the soleplate (5) temperature reaches the set
one, the indicator (12) will glow constantly, you can
start ironing.
• During the operation hold the iron by the handle (8).
• To switch the steam supply on, press the steam
supply button (6) « », for constant steam supply,
press and hold the button (6), to switch the steam
supply off, release the button (6).
• Before starting work, you need to release some
steam, because condensate may accumulate in the
steam pipe (9), to do this, press the steam supply
button (8) « », directing the steam, for example,
onto a kitchen towel, drops of water and steam will
come out of the holes of the iron soleplate (6).
Notes:
- when the unit is switched on for the first time a
foreign smell can appear - it is normal and is not
covered by warranty;
- each time you press the steam supply button (8)
« », the pump is switched on, the operation of
which is accompanied by a characteristic sound;
- when the water in the tank (2) runs out, the pump
sound will be much louder, turn off the device by
pressing the on/off button (12), unplug the power
cord (13), open the lid (3) (Fig. 3) pour water into
the tank (2), close the lid (3) (Fig. 3), turn on the
device and continue working;
- during operation, the steam pressure may
change slightly, since with prolonged vaporization
the water temperature in the steam chamber
decreases by several degrees, if you take a short
break in operation, then the steam pressure will
automatically recover;
- make sure that the steam pipe (11) doesn’t bend
and twist during the operation.
• During breaks and after operation place the iron on
the steam station body (1) in the iron installation