BRAVE Steel
–
User and service manual 33
4 Parameter programming
4.1 Programming with the help of a phone
4.1.1 Entry into the programming
There are two
ways to enter the Brave‟s programming system:
1. With the help of a password
–incoming calls only! – pick up a phone
and dial the number that the Brave is connected to
(either the number of
the branch, if you are connected to a switchboard line, or the number of the
line to the building, where the Brave is and ask be connected to the branch to
which the Brave is connected)
. The brave will pick up (you will hear the
pick-up tone
– see chapter 3.1 page 27) within 10 secs. press „
#xxxx’
,
where xxxx is the service password to enter the programme system
(in
the basic setting xxxx=0000)
, if correct there will be a programming
entry tone followed immediately by a programming tone (see chapter
3.1 page.27).
2.
With the help of DIP 1
"SERVICE"
–incoming call only! – connect to
the Brave as in part 1 above, but where the DIP switch is in position 1
“on”, the Brave will go straight to the programming regime – you will
hear the pick-up tone for entry to programming followed immediately by
the programming tone (see chapter 3.1 page.27).
Do not forget to put DIP switch to position “off” at the end.
4.1.2 Parameter programming
The default state for programming is announced with a programming
tone, the Brave always returns to this state after a specified time (5sec),
whether you started programming or not.
There are two types of parameters used during programming. These are
parameters with a
fixed length
, which is the majority of them, when
programming is confirmed after it fulfils the mandatory length and is
immediately „written in‟ with a
confirming tone
and parameters
with variable
length
(
parameters 1,2,32,33,34
) when the
confirmation
is made only after
time of inaction (5 sec). The only case when there is an immediate „writing in‟
of parameters is when the maximum number of „written in‟ signs (numbers) are
filled up, for parameters
1 and 2
it is 24, for parameters
32,33,34
it is 6.
If you input a number (sign) that is unacceptable during the programming
the Brave immediately sends an
error tone
, the parameter is not „written in
„and the Brave reverts to a default state where it is possible to either repeat the
parameter programming or start programming a different parameter.
The Brave will automatically disconnect form the programming regime
after a period of inaction, 30 sec. With each DTMF tone dialled the time will
always resets to 30 sec. It is also possible to end the programming regime by
choosing parameter 9.
