7
Interference
Should initial reception fail, the reception symbol changes
to a flashing, empty circle. In this case, move the clock to
another position where reception is better.
If the clock is not being set automatically (no reception), it
can be set manually.
Should contact to the radio signal be restored, the time will
automatically be adjusted according to the signal received.
Manual time / date setting
In the case of no reception during 10 minutes or if you wish
to set the time before reception, set the time manually
using the button pad (2) .
1. Press the «set» button to switch to the set mode.
If reception failed, the clock switches automatically to
the set mode and the first digit of the time line flashes.
2. Enter the time digit by digit – as they are flashing – using
the number buttons. Senseless input is not accepted.
The digit to be entered keeps on flashing.
To correct / clear the input, press the «set» button and
start with the first flashing digit again.
3. After time has been entered completely, press the
«enter» button to confirm.
4. The second display line changes to «date» and you can
enter the date manually: Enter the date (DD.MM.) digit
by digit as they are flashing.
After the last digit of the date is entered, set the day of
week:
On default, Monday «Mo» is flashing. Press the button
for the actual day and the corresponding day in the
lower display line is circled. Press the «enter» button to
quit the set mode. By doing so, the time entered is
saved as internal time and seconds are set to 00.
With the next valid reception of the time signal, the time will
be adjusted automatically.
Quartz mode
The clock may also be switched to the quartz mode
(no more time signal reception). Press the «set» and «enter»
buttons simultaneously for a minimum of 3 seconds.
Time and date can be set as described above. In quartz
mode, the display does not show the symbol for failed
reception.
In order re-activate the radio control feature, reset the
clock by removing and inserting the batteries again.
Display functions
Using the time/date/temp button (•••), you can toggle the
lower display line between seconds, date (DD.MM.) and
temperature in °C.
Alarm functions
You can set two alarm times with different alarm tones.
Setting the alarm times
To set an alarm time, press the «time» button belonging to
alarm 1 or alarm 2.
The lower display line shows default setting 12:00 or the
last alarm time entered.
Press the «set» button to enter the set mode. Enter the
alarm time – digit by digit as they flash. After the last digit
is entered, you may choose the days of the week on which
the alarm shall be active. Small triangles in the bottom line
3834200_DB15_MN Seite 7 Donnerstag, 6. Juli 2006 1:26 13
