Page 37
Maintenance and Lubrication Schedule
Resecure, replace or correct as needed
Use Dextron III transmission fluid. Check fluid
level with
platform lowered fully
. Fill to within
1/2" of the bottom of the 1-1/2" fill tube (neck).
Tighten, repair or replace if needed.
Replace if needed.
Tighten or replace if needed.
Tighten or replace if needed.
Replace and lubricate if needed.
Replace if needed.
Tighten, replace or correct as needed
Apply Door-Ease or replace if needed. See
Lubrication diagram.
Resecure or replace if needed.
Resecure, repair or replace if needed.
Check to see that the lift is securely anchored to
the vehicle and there are no loose bolts, broken
welds, or stress fractures.
Replace decals if worn, missing or illegible.
Replace antiskid if worn or missing. See Decals
and Antiskid section on pages 61B-64.
Inspect cotter pins on platform pivot pins (2)
Hydraulic Fluid (Pump) - Check level.
Note:
Fluid
should be changed if there is visible contamination.
Inspect the hydraulic system (cylinder, hoses,
fittings, seals, etc.) for leaks if fluid level is low.
Inspect cylinders, fittings and hydraulic connections
for wear, damage or leaks
Inspect parallel arms, bushings and pivot pins for
visible wear or damage
Inspect base plate tower/parallel arm pivot pin
mounting bolts (4)
Inspect vertical arm/parallel arm pivot pin mounting
bolts (4)
Inspect vertical arms, handrails and pivot pins for
visible wear or damage
Inspect upper/lower fold arms, rotating pivot slide
arms, slide support arms, associated pivot pins,
bushings and bearings for visible wear or damage
Inspect gas springs (cylinders) for wear or damage,
proper operation and positive securement
Inspect rotating pivot slide arm UHMW slide
bearings (buttons)
Inspect vertical arm plastic covers
Inspect power cable
Mounting
Decals and Antiskid
Repeat all
previously listed inspection, lubrication
and maintenance procedures at 4 week or 400
cycle intervals.
1 Year
or
4800
Cycles
Perform all procedures listed in previous sections also
Consecutive
4 Week or
400 Cycle
Intervals
Specified (recommended)
Available
Braun
Lubricant
Type
Lubricant
Amount
Part No.
LO - Light Oil
DE - Door-Ease
Light Grease
Lubriplate
14 oz.
(Multipurpose)
Can
LG - Light Grease
15807
15806
15805
Light Penetrating Oil
LPS2, General Purpose
11 oz.
(30 weight or equivalent)
Penetrating Oil
Aerosol Can
Stainless Stick
Door-Ease
1.68 oz.
Style (tube)
Stick (tube)
Summary of Contents for CENTURY CL917IB
Page 58: ...Page 38 Note Note This page intentionally left blank...
Page 94: ......
