Page 36
Perform all procedures listed in previous section also
3 Months
or
1200
Cycles
Roll stop foot pivot bearings (2)
Upper/lower fold arm telescoping area (2)
Platform pivot pin bearings (4)
Platform fold axles (2)
Inboard barrier lever bearings (2)
Inboard barrier lever slot (2)
Rotating pivot slide arm pivot pin (2)
Parallel arm pivot pin bearings (16)
Handrail pivot pin bearings (4)
Hydraulic cylinder bushings (8)
Inspect Lift-Tite
™
latch catch rollers (2) for wear or
damage and positive securement
Inspect outboard roll stop feet (2) for proper
operation, positive securement, and detached or
missing torsion spring
Inspect inboard roll stop for:
• Wear or damage
• Proper operation. Roll Stop should just rest on
top surface of the base plate.
• Positive securement (both ends)
Inspect handrail components for wear or damage,
and for proper operation
Check adjustment of platform sensor (fold) switch
(pump-mounted hydraulic pressure switch)
Inspect platform fold axles and bearings for wear
or damage and positive securement.
Inspect microswitches for securement and proper
adjustment.
Make sure lift operates smoothly
Inspect external snap rings:
• Platform slide/rotate pivot pins (2 per pin)
• Platform fold axles (1 per axle)
• Inboard roll stop lever bracket pins (1 per pin)
• Lift-Tite
™
latch gas (dampening) spring (2 per spring)
Remove pump module cover and inspect:
• Hydraulic hoses, fittings and connections for wear
or leaks
• Harness cables, wires, terminals and connections
for securement or damage
• Circuit breaker and solenoids for securement or
damage
Apply Light Grease - See Lubrication Diagram
Apply Light Grease - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Correct, replace defective parts and/or lubricate.
Apply Light Oil - See Lubrication Diagram
Correct or replace defective parts and/or
relubricate. See Lubrication Diagram.
Resecure, replace or correct as needed. See
Platform Angle Instructions and Floor Level
Guideline Adjustments.
Replace defective parts.
Adjust or replace as needed. See Systems
Descriptions for details and procedures.
Replace defective parts and resecure as needed.
Apply Light Oil.
Resecure, replace or adjust as needed. See
Systems Descriptions for Microswitches.
Realign towers. Lubricate or correct as needed.
Resecure or replace if needed.
Resecure, replace or correct as needed.
Maintenance and Lubrication Schedule
Summary of Contents for CENTURY CL917IB
Page 58: ...Page 38 Note Note This page intentionally left blank...
Page 94: ......
