Configuring BACnet
If using BACnet, the panel will need to be configured properly to establish communication with
a BMS. Navigate to
Settings > BACnet Settings
. Selecting “Manual” will enable editing of the
IP address, subnet mask, and gateway address using the arrows in a pop-up window.
Pressing and holding the arrows for 5 seconds will enable quick scroll to make larger changes
easier. Selecting “DHCP” will use Dynamic Host Configuration Protocol to automatically
assign network parameters. Follow the instructions provided with the BACnet client device for
connecting a server device. Read the Brasch BACnet PICS for more information about the
GDCP-Touch capabilities.
Performing a Reset
Should too many changes be made that cause the panel to operate in an undesirable manner,
Two options are available to reset the GDCP-Touch under
Settings > Reset Options
. “Reset to
Default” will erase any custom sensor, relay, or zone settings while leaving all assignments
intact. “Factory Reset” will completely erase the configured system and return the panel to
basic factory settings. Only perform a factory reset after consulting with Brasch Technical
Support.
IOM03
Rev 1.1 – May 18, 2021
38