Setting Automatic Overrides
Each relay can schedule up to four separate times for an automatic override. Of these times,
three may be used to force the relay into an active state while one may be used to force it into
an inactive state. Navigate to
Settings > Relay Settings > Relay #
and select “Auto” to open
the pop-up window. Use the arrows to select the time when the scheduled override should
begin and the duration the override should last. Tap the buttons at the bottom to schedule the
days the override should take place. Once a time, duration, and day have been set, the
automatic override is scheduled. To disable the automatic override, either select “None” under
“Relay Override Status”, or remove all days from the automatic override window.
Changing the Date and Time
To change the date or time, go to
Settings > Date/Time Settings
. Then use the arrows to
select the correct date and time. Pressing and holding the arrows for 5 seconds will enable
quick scrolling to make large changes easier. The buttons underneath the time will set the
panel to display in either 12 hour or 24 hour format. The button in the lower left corner will
enable daylight savings time compensation if green. Press “Save” before exiting to save any
changes made.
IOM03
Rev 1.1 – May 18, 2021
37
