BRANNSTROM CleanTrack 1000 B, Operation And Technical Manual, Page: 87 / 232

Brannstrom Sweden AB CleanTrack 1000B - Rev 2.20xd, 2019 Page 87 of 232
"44 Alarm - Low Water Pressure"
Low water pressure in the analyzing unit for 10 seconds.
Indicates a problem on the fresh water supply to the analyzing unit.
“RUNNING” mode is stopped.
See chapter 7.8.5. Pressure , page 69 and 7.8.8. System Configuration, Standard, page 71.
"45 Alarm - Overcurrent"
The over-current protection relay in the Converting Unit is activated.
The cause for an activated relay could be the sample pump pumping against a closed valve or a clogged
pipe. The sample pump itself might be clogged.
Reset the over-current protection relay by pressing the key at the front of the relay. The relay is located to the
left in the Converting Unit.
Operating conditions that require frequent and repeated resetting of the over-current relay might harm the
sample pump.
“RUNNING” mode is stopped.
"46 Alarm – High Pump Temperature"
The high temperature guard connected to terminals 17 and 18 in the Converting Unit is activated.
This indicates a high temperature of the pump shaft seal.
Check shaft seal oil refilling. See chapter 9.7. Sample Pump Shaft seal oil refilling page 93 .
“RUNNING” mode is stopped.
“47 Alarm - Indicating Flushing Water”
The unit is in “RUNNING” mode and the “ZD4” input is active.
Close the water valve. See chapter 7.8.8. System Configuration, Standard page 71 .
“RUNNING” mode is stopped.
8.8. Paper Printer alarms
The Computer PCB (master) is communicating with the Paper Printer continuously and will give Printer alarm
immediately.
The unit cannot discharge with one of the paper printer alarms remaining.
Press the "Alarm Reset"-key in the "Alarm Table" to reset the alarm and try to fix the fault.
See chapter
7.3. Alarm Table
, page
53.
However, the printer can be deselected in the Setup menu. See chapter 7.8.8. System Configuration, Standard page 71
Printer hardware is RS232 and baudrate is 9600 baud.
"50 Alarm – Printer Busy"
"51 Alarm – Printer Busy (Xoff)"
Printer is busy and do not accept more printouts.
Check cable connections to the printer and that printer paper is correctly installed.
"52 Alarm – Printer Feedback Error"
Wrong format on printer reply. Check cable connections to the printer and its baudrate settings.
"53 Alarm – Printer Cover Open"
"54 Alarm – Printer Paper End/Cover Open"
Printer has no paper or its paper cover is open. Check the printer paper and its cover.
"55 Alarm – Printer Head Temp Error"
If this alarm remains the printer need to be replaced.
"56 Alarm – Printer Voltage Error"
If this alarm remains the printer and/or the CUIO PCB connected to the printer need to be replaced.
"57 Alarm – Printer Feedback Missing"
No reply from Printer. Check cable connections to the printer.
"58 Alarm – Printer Buffer Overflow"
Printer buffer has overflow. Printer busy do not work, check cable connections to the printer.
If this alarm remains the printer and/or the CUIO PCB connected to the printer need to be replaced.