BRANNSTROM CleanTrack 1000 B, Operation And Technical Manual, Page: 15 / 232

Brannstrom Sweden AB CleanTrack 1000B - Rev 2.20xd, 2019 Page 15 of 232
4. Installation
This chapter contains advice for the installation of CleanTrack 1000 B equipment on board tankers. The advice given in
this chapter is of general validity and should be supplemented with a detailed installation specification for the particular
ship. Additionally, all applicable regulations regarding the installation standard, issued by the relevant authorities and
classification society must be followed.
For instance, if CENELEC applies, compliance is required with EN 60079-14 and EN 60079-17.
4.1. Computer Unit
4.1.1. Mechanical
Refer to drawings/chapters:
• CTB10030 sheet 1, chapter 10.1. Computer Unit page 97 . Both wall and panel mount options are shown.
•
P3715090 sheet 1, Computer Unit panel mount instructions page 99 .
The Computer Unit is installed in the cargo control room or an equivalent dry and non-hazardous area.
4.1.2. Electrical
Refer to one of the drawings below:
• CTB110204.1el, chapter
10.10.1. Electrical cable diagram for electrical Ex. motor sample pump
page
138
.
• CTB110204.1bh, chapter 10.10.2. Electrical cable diagram for bulkhead mounted sample pump page 139 .
•
CTB110204.1pn, chapter 10.10.3. Electrical cable diagram for air motor sample pump page 140 .
Supply voltage should be single phase 110/220VAC, 50-60Hz.
(Computer unit work on voltages 85 - 265VAC).
Power consumption 30VA.
The power should be equipped with a main switch, or if specified, a detachable connector.
The fuse size should be 6A.
The alarm relay is normally open. An activated alarm is indicated with an open relay, which means that the alarm is
activated when the power supply fails.
Data communication between Computer Unit and Converting Unit, Cb5:
Type: RS485
Baudrate: 19200 baud.
Length: ≤1200 meters. (Might be shorter depending on cable used, see RS485 standards.)