BRANNSTROM CleanTrack 1000 B, Operation And Technical Manual, Page: 46 / 232

Brannstrom Sweden AB CleanTrack 1000B - Rev 2.20xd, 2019 Page 46 of 232
7.2. Operation
7.2.1. Running
All important information during “RUNNING” mode of the system is displayed.
Use “Running Settings” for all settings before a discharge.
The piping arrangement turns blue or grey depending on input / output signal status.
•
Overboard valve is grey, indicating closed, and slop tank valve is blue, indicating open.
• The water sensor in the measuring cell is not active and this is displayed with grey sample lines. The sample
lines turn blue when the water sensor is activated.
•
The "Sample pump" turn blue when its control output is on.
• The “Water”-valve turn blue when its control output is on.
• The Overboard line turns blue when the measured discharge flow is within the flow limits.
•
Indications counting down seconds can be displayed, indicating that the unit is waiting for an event. These
indications are for information only and can be ignored, alarms are generated for failures.
"Oil type" Indicates the selected “Oil type”. Select in the “Running Settings”-menu.
"Discharge Line" Indicates the selected “Discharge Line” Select in the “Running Settings”-menu.
"START Discharge"
Starts the unit for discharging of the water.
Refer to Chapter 5. Start/Stop procedure page 38 before starting discharge.
When the unit goes into “RUNNING” mode, the key which previously was called "START
Discharge" will now display the text "STOP Discharge".
A submenu is displayed asking for START verification, or if any input signal or other
selection prohibits the START, the "Status” menu indicating the reason will be shown.
"Alarm Reset" A RED “Alarm Reset” - key pops up above the “Main Menu” key. It there are any active
alarms which have not been acknowledged, the “Alarm” indication on top right is flashing.
Same function as the "Reset" key in the "Alarm table".
“Enable test of: Pump & Water” Enables manual running of the Sample Pump and opening of the Water Valve.
This selection needs to be verified on a popup window.
The two keys below will be shown after the “Enable test ...” key has been pressed.
Refer to Chapter
5. Start/Stop procedure
page
38
before activation of pump or water.
"Pump 60 sec" Manually run the sample pump for 60 seconds, useful for testing.
Pressure check and Water check is enabled and may prohibit start of the pump. Further
described in chapter 7.2.4. Status page 52 below.
"Water 60 sec"
Manually flush with fresh water for 60 seconds (if automatic flushing has been installed),
useful for testing.
“Man. Close” Option for “Valve control” settings “EL1/EL2” and “EL1/EL2-n”. Activate relay output for
closing of slop tank valve. Refer to chapter 7.8.1. Line of discharge page 67 .
“Conv. Unit” Option for an “Extended” converting unit. A table showing sample pump motor data.
“Show Motor” Option for an “Extended” converting unit. Showing the “Conv. Unit” table above.
Only for Extended
Converting unit
Only for Valve Control:
EL1/EL2 or EL1/EL2-n
Indicating “opening” or “closing” while
discharge output and feedback indicated
on valves do not correspond.