BRANNSTROM CleanTrack 1000 B, Operation And Technical Manual, Page: 72 / 232

Brannstrom Sweden AB CleanTrack 1000B - Rev 2.20xd, 2019 Page 72 of 232
“PumpFeedback” When upgrading the software to version 2.20x it is recommended to upgrade
converting units made for an electrical sample pump according to drawing,
CTB110627.1el, internal cable diagram for electrical sample pump motor
page
141 .
The computer unit monitors the feedback of the sample pump start/stop contactor
position and raise an alarm if the feedback is unexpected.
An open contactor (pump not running) is indicated with a closed feedback.
Converting unit I/O pcb: ”CVNT_C”.
“NoPumpFeedback” Setting for units without sample pump feedback and for units with air driven sample
pump.
For units with an electrical sample pump it is recommended to install the pump
feedback.
Converting unit I/O pcb: ”CVNT_C”.
“Extended” (Option) Setting for specially equipped converting units only, with means for monitoring
pump motor performance and heating the motor during “StandBy” mode.
The Extended Converting unit can only be combined with the SPP-100 sample
pump.
Extended units have the sample pump contactor feedback wired.
See drawing:
CTB110627.1elext
page
142
.
Converting unit I/O pcb: ”CVCT_B”.
“Extended-NoLim” (Option) Same as “Extended” above except for 2 disabled alarms:
"62 Alarm – Sample pump Motor Phase Error"
"63 Alarm – Sample pump Motor Limits" .
See chapter 8.9. Extended Converting unit Motor alarms (Optional) page 88 .
“Freeze Risk Alarm” A freeze risk alarm is raised if the temperature in the Measuring cell is below 4°C
and the water sensor is active. The alarm is raised only once and will not be
activated again unless the Measuring cell temperature first has increased above 8°C.
“PumpMotorDisconnect” Support of a manual disconnector switch between the Converting unit and the
sample pump motor. The computer unit can monitor the switch position.
The alarm should be deselected or wired in the Converting unit.
Connect to terminals 13, 14 on the Converting unit I/O pcb.
“ManualWithFeedback” The computer unit monitors the switch position and raises an alarm if the switch
remains in the wrong position at touch screen timeout (about 30 minutes).
“NoManualSwitch” No disconnector switch is installed.
"PaperPrinter" Select whether a paper printer is installed of not.
If “NO” no printouts are made and no printer alarms are generated.
If “YES” the same printouts that are made to “Recorded data” are made on the
printer. Printer errors will stop overboard discharging.
“ExternalModbus” (Option) A modbus RTU master that can over an RS485 line send data to other equipment.
This needs a specially equipped CUIO board. Connect on terminals 44-46.
Use of this optional CUIO-board is not included in this manual.
Setting should normally be “No” .
"VoyageDataRecorder"
(Option) A NMEA sentence is sent for every line added to “Recoded data”.
This needs a CUIO board of version “L” or later, connect on terminals 41-43.
Setting should normally be “No” .
Note! A paper printer cannot be used together with this option.
Messages are sent as "Proprietary Sentences", and their compositions are:
"$PCTB","Recorded data line","*",2 bytes checksum,Carriage Return,Line Feed.
Baudrate=4800, Parity=None, Data bits=8.
"Contact Information" Contact information can be displayed in the "Start menu" and in the
"Alarm table".