MANUAL P/N 900000108 REV D
16
4.2.1
IPSetup.exe
To set up the network address using the IP Setup program, follow the steps given below. Please note
that IPSetup uses a local broadcast on UDP port 20034.
1.
Download the IP Setup program from the NetBurner website located at
http://www.netburner.com/support/public_downloads.html
.
2.
Double click on the IPSetup.exe icon and Figure 2 will be displayed.
Figure 2 NetBurner IPSetup Screen
3.
Verify that the “Select a Unit” displays the current MAC and IP address of the ENTA unit
connected to the network.
4.
Click on the ENTA unit that needs to be configured. Please note that the ENTA unit is
identified by MOD5272.
5.
Enter the NDK Settings (IP, Network Mask, GateWay, and DNS).
6.
To transfer the NDK Settings to the selected ENTA unit, click the
button.
7.
Wait 15 seconds for the NDK Settings to be loaded into the ENTA unit and for the ENTA unit
to restart.
8.
Verify that the ENTA unit has the correct NDK Settings and is connected to the network by
clicking the Search Again button.
9.
To exit the IP Setup program, click the Close button.
10.
Open a web browser, type the IP Address of the ENTA unit in the Address bar, and press
<Enter>. For example, type 192.168.1.240 or
http://192.168.1.240
and press <Enter>.
11.
Figure 3 will be displayed.
12.
Configure the ENTA unit. For more information on ENTA configuration, refer to the
Configuration section of the user guide.
IMPORTANT INFORMATION:
If the new NDK Settings make the ENTA unit inaccessible from the setup computer, the IP
Setup program won’t be able to locate the ENTA unit on the network.
