MANUAL P/N 900000108 REV D
15
4
Getting Started
4.1
Powering Up the ENTA
Once all connections to the ENTA have been made, apply power to the unit by setting the On/Off
switch to the on position. The On/Off switch is located on the rear panel power entry module.
The POWER LED on the front panel should be illuminated green within 2 seconds. The POWER LED
indicates that the ENTA has power.
Once the GPS has acquired satellites, time should be displayed on the front panel in the format:
HH:MM:SS.
4.2
Setting the Network Address
The ENTA is shipped with a label that indicates the IP address stored in the unit. The default settings
are:
•
IP Address: 192.168.1.240
•
Subnet Mask: 255.255.255.0
•
Gateway: 192.168.1.1
To set the network address, the user may use either IPSetup.exe or a web browser. The two
processes are described below.
