Electricity supply
For your safety, you must comply with
the instructions below.
The electrical installation must comply with
Standard NF C 15-100,
particularly as
regards the Earthing requirements.
Line 3x2.5 mm2 single-phase 230V connected
to :
- A single-phase 20A 230V-50Hz meter
- A differential circuit breaker and a separate
fuse (10 or 16A, depending on the model)
- A 2-pin +
Earth
10/16A socket
We cannot be held responsible for any
accident caused by improper electrical
installation.
Advice on the electrical installation of your
machine:
• Do not use an extension lead, an adapter or
a multiple-outlet socket.
•
Never
remove the Earth.
• The socket must be easily accessible but out
of the reach of children.
If in any doubt at all, please contact your
installer.
88
GB
Connecting your machine
Fig. 7
Fig. 8
Draining away the waste water
Connect the drain hose
(Fig. 7):
• Either, temporarily, to a sink or a bath tub
• Or, permanently, to a ventilated U bend.
If your installation does not have a ventilated
U bend, ensure that the connection is not
airtight. In fact, to avoid any flowback of the
waste water into the machine, you are
strongly recommended to leave an air gap
between the drain hose and the waste pipe.
The hose must not be twisted or kinked and
must be held by the hose hook to avoid it
falling to the ground
(Fig. 8).
The hose hook must be placed 40 to
100 cm above the base of the machine.
Ensure that it is tied firmly in place to
avoid it coming loose during draining
and causing a flood.
Your machine complies with European
Directives EEC/73/23 (Low Voltage Directive)
and EEC/89/336 (Electromagnetic
Compatibility) as modified by Directive
EEC/93/68.
