18
then brush them with the use of a sponge or a soft brush.
• If the light bowl is dirty, switch off the appliance, unscrew the bowl, and
wash and dry it thoroughly (fig. 7.6.)
• Enamelled ovens are coated with ceramic enamel.
• For enamel surfaces use kitchen-cleaning agents.
• For removing difficult baking stains, special oven cleaning agents are
recommended. However, these agents are caustic and therefore should be
used in small quantities and with utmost care. Please follow the manu-
facturer’s instructions carefully.
7.5 Catalytic Walls
Catalytic walls are located on the left and the right side of cavity under
the guides. Catalytic walls banish the bad smell and obtain the best per-
formance from the cooker.
Catalytic walls also absorb oil residue and clean your oven while it’s op-
erating.
Removing the catalytic walls:
In order to remove the catalytic walls; the
guides must be pulled out. As soon as the guides are pulled out, the
catalytic walls will be released automatically. The catalytic walls must be
changed after 2-3 years. (fig. 7.5)
8.Troubleshooting
NOTE !
Before proceeding with the troubleshooting, disconnect the cooker from
the power supply to avoid being electrocuted.
• In the warranty period all repairs except for the ones specified below
should be carried out by the authorised Servicing Point.
• If there are some disturbances during the use of the appliance, follow
the guidelines below to check if you can repair the defect yourself.
