PC Elite Reference
Installation Guide
CHAPTER 2
PC ELITE
INSTALLATION
GUIDE.
Introduction.
____________
This chapter explains how to configure and install the PC
ELITE IEEE board into an IBM PC computer. Detailed
instructions are given how to set the address select and interrupt
acknowledge DIP switches and how to position the IRQ and
DMA jumpers.
If the PC ELITE IEEE is to be installed in another make
of PC then it may be necessary to consult the instructions
included in that PC’s documentation.
The half size PC ELITE IEEE board will fit into both long
or a short slots, it can be placed in standard 8 bit PC slots or in
the longer 16 bit AT slots. If interrupts 10, 11, 12 or 15 are to
be used then the card must be installed in a 16 bit AT expansion
slot.
If you have a Micro Channel Architecture computer such
as the IBM PS/2 Models 50, 60 or 80 or a Tandy 5000 M.C.
then you require our PS Elite/2 card instead.
Configuring The PC ELITE IEEE Board.
____________________________________
In the state it leaves our factory, the PC ELITE IEEE 488
Interface Board is ready to plug straight into an IBM PC
computer.
So, unless you have GOOD REASON, you do not need to
alter its default setting.
2-10
Chapter 2
