bq witbox 2, Quick Start Manual

Page: 31 / 36

30
EN
Troubleshooting.
Common issues
I can’t load the filament into the extruder
Cut the end of the filament. Discard any areas which have been damaged, folded
or bent. Check that there are no traces of previous filament remaining in the
guide tube.
When the printing is complete, I can’t remove the pieces.
This is due to the extruder being too close the bed, which makes the first layer of
the pieces adhere excessively.
To remove the piece, place the print bed in hot water. If you are still unable to
detach it, use the spatula or a similar object to carefully detach the edges.
To avoid this from happening again, go back to adjust the offset and set the
extruder at a greater distance away from the bed.
The piece doesn’t stick to the print bed
This is due to the extruder being too far away from the bed. Adjust the offset again
if you are using auto-levelling, or readjust it manually to reduce the distance
between the extruder nozzle and the print bed. Use lacquer, Fixpad or tape make it
stick the print bed.