
28
EN
14.
Guide the cables into place and cable them.
15.
Switch on the printer.
16.
Make sure that everything is correctly connected by following these steps.
Firstly, set the temperature via the main menu.
Secondly, check that the temperature is rising. If so, then the heat
cartridges are connected correctly.
17.
To adjust the offset, go to
Settings > Offset
.
18.
Load the filament to make sure that the hot-end is working correctly.
19.
Level the print bed. If auto-levelling is enabled, this will be done automatically.
20.
Print out an object to check that everything has been done correctly.
Kill switch
Your Witbox 2 is equipped with a kill switch system which enables you to stop any
process immediately, in the event of detecting a fault.
To do this, press and hold the control wheel until you here a beep. The Witbox 2
system will shut down and then restart with a warning screen. Press and hold the
control wheel again until the warning screen has disappeared and the main menu
has returned. If you were printing when you enabled the kill switch, the print job
will not be resumed.
Summary of Contents for witbox 2
