21
EN
Enabling/Disabling auto-levelling
Go to
Settings > Auto-levelling
. It is enabled by default (
ON
). Press the control
wheel to disable it (
OFF
). If auto-levelling is disabled, you will need to level the
bed manually.
Levelling the bed manually
To level your Witbox 2 manually, press Level bed to start the process.
The printer will take a reading from the centre of the bed and will move to the first
front left point. If the red LED of the sensor lights up, it means that the distance
between the bed and the extruder is correct. If it blinks, you will need to turn the
knurled wheel below which corresponds to this point, in order to move the bed on the
Z axis until the LED stops blinking.
Repeat this step with the front right and the central rear points, adjusting the
wheel on each side respectively until the LED lights up.
Summary of Contents for witbox 2
