bq witbox 2, Quick Start Manual

Page: 13 / 36

12
EN
Attaching the side panels
Find the side panels in the accessories box. Remove the plastic protectors from
each side.
Gently loosen the four screws located on the sides of the printer (two on
each side). Use the 4 mm Allen key to do this. Once you have loosened them,
slide the side panels in towards the rear of the printer and then tighten the
screws again.
Open the door at the front using the set of keys included in the accessories box.
Removing the protective cover from the extruder
The extruder of your Witbox 2 is immobilised with a protective cover to prevent
damage during transport..
To take it off, first remove the screws located at the back and then lift off the
shield. Keep it safe so that you can re-use it for transportation.