Page 05
If your vehicle is a Nissan, Toyota, follow
this mounting instruction. Use the screw
holes marked T (Toyota), N (Nissan)
located on both sides of the unit to fasten
the unit to the factory radio mounting
brackets supplied with your vehicle.
Fasten the unit to the factory radio
mounting brackets. Align the screw holes
on the bracket with the screw holes on
the unit, and then tighten the screws
(5x5mm) on each side.
Note: the outer trim ring, sleeve and the
metal strap are not used for method B
installation.
2. DIN REAR-MOUNT (Method B)
Removing the unit
1. Make sure the ignition is turned off,
and then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Remove the metal strap attached the
back of the unit (if attached).
3. Press the release button to remove the
front panel.
4. Lift the top of the outer trim ring then
pull it out to remove it.
5. Insert both of the supplied keys into
the slots at the middle left and right sides
of the unit then pull the unit out of the
dashboard.
Using the detachable front panel
2 Grasp the right side of the front panel,
then gently push the front panel towards
the left side before pulling it out from the
unit.
.
3 Store the front panel in the protective
case provided for safe keeping.
.
Removing and protecting detachable
front panel
1
2
front panel
front panel
OPEN button
protective case
TO ATTACH THE FRONT PANEL
Hold the right side of the front panel with
the plate facing down.
First attach the left side of the front panel
to the unit by inserting the hole into the
left holder.
Then slightly push it leftwards and attach
the right side hole into the right holder.
Finally push up the front panel.
The front panel of the unit may be removed
as a theft deterrent. After removing the
front panel, use the case provided to keep
the front panel from getting damaged.
1 Press the OPEN
button to flip down
the front panel.
.
