Page 26
9e1072
5.1 PULSE MD STALL ID ASSIGNATION
Every new Pulse MD is required to be assigned to the stall number where it has been installed. In order to assign a Stall
ID refer to
Figure 26
.
5. TESTING & ADJUSTMENTS TO THE SYSTEM
26.
Assigning Stall ID
27.
Identified Pulse MDs in the Network
Completing the steps in
Figure 26
will bring a list of all Pulse MD’s identified in the network. See
Figure 27
. Each line
corresponds to a Pulse MD located in that particular CAN network.
• Refering to
Figure 27
, touching the first button on each line with the symbol
will cause that particular
Pulse MD to blink in the installation. This will locate the stall number were that particular device is mounted.
The number shown inside the first button corresponds with the device serial number.
• Touching the second button will show the firmware version number which that particular Pulse MD is running.
• Touching the grey button will allow the user to assign a Stall ID to that particular Pulse MD.
