- 32 -
4.2.13 Overload
In order to avoid damages as a result of excess temperatures during continuous operation
it is important to observe sufficient break times during the installation process.
If the tool should go into an automatic shut-down (TEMP FET)
as a result of excess temperatures the break times should
be reviewed and adjusted.
Continued work is only possible after a cooling off period in order to protect the tool from
lasting damage.
4.2.14 Standby and Shut-down mode
After approx. 10 minutes without actuation → the tool switches to standby mode
The tool starts up again by briefly tapping on the start button.
After another approx. 30 minutes without actuation → automatic shut-down
Start-up by pressing the start button if the battery has not yet been removed, or right
after sliding the battery back on. Both are only possible if the battery has sufficient charge
capacity.
NOTE
In the case of longer period of non-use (longer than 3 hours) the battery must
be separated from the tool in order to prevent deep discharge of the battery.
TEMP FET
STOP