Boss GT-001, Parameter Manual

Page: 21 / 48

EFFECT
21
Knob Parameter Value Explanation
Page 2
[1]
E .LEVEL
(EFFECT LEVEL)
0–100
Adjusts the volume of the
effect sound.
[2]
DIR .MIX
(DIRECT MIX)
0–100
Adjusts the volume of the
direct sound.
FOOT VOLUME
FOOT VOLUME
This is a volume control effect.
It’s controlled by the expression pedal connected to the CTL/EXP
jack.
Knob Parameter Value Explanation
[1]
MIN
(VOLUME
MIN)
0–100
Sets the volume when the heel of the EXP
Pedal is depressed.
[2]
MAX
(VOLUME
MAX)
0–100
Selects the volume when the toe of the
EXP Pedal is depressed.
[3]
CURVE
(VOLUME
CURVE)
SLOW 1,
SLOW 2,
NORMAL,
FAST
You can select how the actual volume
changes relative to the amount the pedal
is pressed.
NO
RM
AL
SLO
W
2
SLO
W
1
FAS
T
Minor
When the pedal is
fully raised
When the
pedal is fully
advanced
Volume
[4] LEVEL 0–100 Adjusts the volume.
DIVIDER
Within the effect chain, the point where the signal is split into
channels “A” and “B” is called the “divider,” and the point where the
two signals are recombined is called the “mixer.”
You can use the divider to switch between channels “A” and “B,” to
assign strongly picked notes and softly picked notes to different
channels, or to assign different frequency bands of your guitar
sound to different channels.
The mixer lets you adjust the volume balance of channels “A” and “B,”
place them in the stereo field, or slightly delay the sound of channel
“B” to produce a spacious sound.
DIVIDER MIXER
Knob Parameter Value Explanation
Page 1
[1] MODE
SINGLE Use only one channel, either “A” or “B.”
DUAL Use the two channels “A” and “B.”
SINGLE
If “SINGLE” is selected in [1]
Knob Parameter Value Explanation
Page 1
[2]
CH .SEL
(CHANNEL SELECT)
Ch. A,
Ch. B
Selects the channel to use.
DUAL Ch. A, DUAL Ch. B
If “DUAL” is selected in [1]
Knob Parameter Value Explanation
Page 2, 3
[1]
A:DYN
(Ch .A:DYNAMIC)
B:DYN
(Ch .B:DYNAMIC)
OFF DYNAMIC will not be used.
POLAR+
Only notes picked more
strongly than the DYNAMIC
SENS setting will be output.
POLAR-
Only notes picked more
softly than the DYNAMIC SENS
setting will be output.
[2]
A:SENS
(Ch .A:DYNAMIC SENS)
B:SENS
(Ch .B:DYNAMIC SENS)
0–100 Specifies the picking sensitivity.
[3]
A:FILTR
(Ch .A:FILTER)
B:FILTR
(Ch .B:FILTER)
OFF The filter will not be used.
LPF
Only the region below the
cutoff frequency will be
output.
HPF
Only the region above the
cutoff frequency will be
output.
[4]
A:CUTOF
(Ch .A:CUTOFF FREQUENCY)
B:CUTOF
(Ch .B:CUTOFF FREQUENCY)
100 Hz–4
kHz
Cutoff frequency