Page 14
STEP 7:
Installing the engine / pump assembly. See FIGURE 9.
1. Insert a vibration isolator underneath the engine at the four mounting hole positions.
2. Secure the engine with the M8 hardware then tighten the bolts using two 13mm wrenches.
REF. NO.
DECSRIPTION
QTY.
12
Engine / Pump assembly
1
13
Hardware kit # 5-1, including:
1
13-1
Hex head bolt / M8 x 40
4
13-2
Flat washer / M8
8
13-3
Lock nut / M8
4
13-4
Vibration isolator /
Ø9
4
STEP 8:
Attach the oil suction hose and pump / valve connecting hose. See FIGURE 10.
There are two hydraulic hoses listed below, each of them has one end already connected to the log splitter by
manufacturer the other open end still needs to be attached.
1. The oil suction hose ¾”, which is labeled as
①
comes from the bottom of the reservoir tank.
Loosen the hose clamp on the open end of this hose using a flat head screwdriver. Then connect the hose to the
fitting on the bottom of the pump which is also labeled with
①
and tighten the hose clamp.
(FIGURE 9)
Page 17
(FIGURE 8)
