26
en | Installation of KBN (Indoor) Cameras
KBN & KBE Series Cameras
4. Attach the housing to the mount using the two (2) 1/4-20
screws and washers provided in the hardware kit. For
additional information, see the LTC 9215/00 Mount
Installation Manual
.
5.3
Camera Lens Adjustment
The camera and lens come factory-configured and ready for
operation. To adjust the camera lens to obtain the required
view, you must access the camera inside the housing.
1. Loosen the top two screws (item 1 in the figure below) on
the rear of the housing. These screws are captive and will
not come out all the way. Do not remove the bottom two
screws.
Figure 5.2
LTC 9480/00 Rear View
2. Grasp the housing's front cap and pull forward. Do not
squeeze the cover itself. This will make it difficult to slide
off the cover.
3. If using an analog camera, remove the coax cable from the
Video BNC connector.
4. Connect a coax cable from the setup monitor to the Video
terminal on the back of the camera.
F.01U.215.198 | 4.0 | 2011.01
Installation Manual
Bosch Security Systems, Inc.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
