KBN & KBE Series Cameras
Installation of KBE (Outdoor) Cameras | en
29
unused hole in the mounting foot of the camera housing as
shown in
Figure 6.3
on
Page 31
.
4. Connect the UTP video cable to the -VID+ pins on UTP
transmitter. Observe polarity; the video connection is
polarity-sensitive.
Figure 6.1
Connect the UTP Cable to the Transmitter
Reference Description
1
Negative (-) terminal for twisted pair video lead
2
Positive (+) terminal for twisted pair video lead
5. Seal the hole in the mounting foot of the camera housing
with RTV or an equivalent seal. If a fitting was used in the
mounting foot, apply the seal around the UTP cable before
tightening the fitting to prevent slippage.
6. Attach the housing to the mount in accordance with the
KBE and KBN Series Instruction Manual.
Wiring Do’s
1. Use point to point unshielded twisted pair wire, 24 AWG or
thicker, stranded or solid, Category 2, 3, 4, or 5.
2. The video signal may coexist in the same wire bundle as
other video, telephone, data, control signals, or low
voltage power.
3. Measure the wire distance. Use only receivers designed for
that distance.
4. Ensure that the pair of wires carrying the video signal is
sent as a twisted pair, not a split pair.
Bosch Security Systems, Inc.
Installation Manual
F.01U.215.198 | 4.0 | 2011.01
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
