26
| English
This allows screws to be driven in even when the battery is discharged and enables the
power tool to be used as a screwdriver.
Preselecting the torque
The torque presetting ring
(3)
can be used to preselect the required torque in six stages.
Once the set torque has been reached, the application tool will be stopped.
Stage 1:
Lower torque for driving in screws with a small diameter or for use with soft materials.
Stage 6:
Higher torque for driving in screws with a large diameter or for use with hard materials.
Switching On and Off
There are two ways to start up the power tool.
– Exert pressure on the spindle and maintain this pressure to continue using the power
tool.
To switch it off
, stop exerting pressure on the spindle.
– Press the On/Off switch
(4)
.
To switch off
, release the on/off switch
(4)
.
Temperature-dependent overload protection
In normal conditions of use, the power tool cannot be overloaded. If the power tool is
overloaded or the permitted battery temperature is exceeded, the electronics of the
power tool will switch off until the temperature returns to within the optimum operating
temperature range.
Protection against deep discharge
The lithium-ion battery is protected against deep discharge by the "Electronic Cell Pro-
tection (ECP)". When the battery is discharged, the power tool is switched off by means
of a protective circuit: The application tool no longer rotates.
Maintenance and Service
Maintenance and Cleaning
u
Before any work on the power tool (e.g. maintenance, tool change, etc.) as well
as during transport and storage, set the rotational direction switch to the middle
position.
There is risk of injury from unintentionally pressing the on/off switch.
u
To ensure safe and efficient operation, always keep the power tool and the vent-
ilation slots clean.
If the battery is no longer working, please contact an authorised after-sales service agent
for
Bosch
power tools.
1 609 92A 5MN | (12.02.2020)
Bosch Power Tools
