Bosch FPA-1000-UL, Installation And Operation Manual

Page: 45 / 140

Analog fire panels Planning Information | en 45
Bosch Security Systems, Inc. Installation and Operation Guide 2017.11 | 2.0 | F.01U.173.607
Use the delay (power-up/start-up) time marked on the label of the smoke detector or on the
installed smoke detector(s).
Circuit (Zone) Delay Time [Seconds] Detector Module Detector Delay
[Seconds]
Tab. 3.28: Detector delay list
– Remote Programming
–
Remote programming must be manually accepted at the panel onsite
– Program non-supervisory and supervisory reports for those points used
– Program trouble reports
– Set the automatic test report frequency to occur at least every 6 hours
– Timer Programming
–
Program Auto Silence Time for not less than five minutes, or to "0" to disable auto-
silence operation
– Point Programming
–
For fire points: open = trouble, latching
– Alarm Output Programming
–
Program the notification appliance circuits (NAC) to activate from the appropriate
zone
– Communications Programming (if Used for Central Station Service)
–
Select a communication format that is compatible with the central station, then
enable both phone lines
3.7 NFPA Standard-specific Requirements
The FPA‑1000 Analog Addressable Fire Panels are designed for use in commercial, industrial
and institutional applications and meet the requirements for service under the National Fire
Protection Association (NFPA 72) standards outlined in this section.
The minimum system components required for compliance with the appropriate NFPA 72
standard are listed below.
FPA‑1000 Analog Addressable Fire
Panel Contains the mainboard, enclosure (back box with
dead front door and door), main power supply
transformer and power supply.
Batteries To calculate required battery capacity, download and
use the Microsoft Excel based
FPA‑1000_Battery_Calculator.xls spreadsheet from
www.boschsecurity.com.
Initiating Devices Connected to one of the control panel's Initiating
Device Circuits.
Notification Appliances Connected to the control panel's Notification Appliance
Circuits through a control module.