12
en | Browser connection
Camera Browser Interface
AM18-Q0649 | v5.8 | 2013.06
Software manual
Bosch Security Systems
1.2
Establishing the connection
The camera must have a valid IP address and a compatible
subnet mask to operate on your network. By default, DHCP is
pre-set at the factory to
ON
and so your DHCP server assigns an
IP address. With no DHCP server the default address is
192.168.0.1
1.
Start the Web browser.
2.
Enter the IP address of the camera as the URL.
3.
During initial installation, confirm any security questions
that appear.
Note:
If you do not connect, the camera may have reached its
maximum number of connections. Depending on the device and
network configuration, each camera can have up to 25 web
browser connections, or up to 50 connections via Bosch Video
Client or Bosch Video Management System.
1.2.1
Password protection in camera
A camera offers the option of limiting access across various
authorization levels. If the camera is password-protected, a
message to enter the password appears.
1.
Enter the user name and the associated password in the
appropriate fields.
2.
Click
OK
. If the password is correct, the desired page is
displayed.
1.3
Protected network
If a RADIUS server is used for network access control (802.1x
authentication), the camera must be configured first. To
configure the camera, connect it directly to a computer using a
network cable and configure the two parameters,
Identity
and
Password
. Only after these have been configured can
communication with the camera via the network occur.
