6 720 643 259 (2010/05)
Information about the appliance
|
9
US/CA
2
Information about the appliance
•
The FB 100 is used to display device and
system information and to change the settings
shown.
•
The FB 100 is prepared for wall mounting.
•
In connection with the IPM 2 module, the
FB 100 controls the assigned heating circuit
using a timer program. Three weekly heating
programs with six switch points per day are
available for a heating circuit (one program is
active).
•
Number of FB 100 per heating system
–
Maximum of four FB 100 in a heating
system with an FW 200.
•
In case of power failure, the display goes out.
All settings are saved. The FB 100 receives the
time and date from the outdoor reset control.
2.1 Technical specifications
2.2 Scope of delivery
Fig. 2
Scope of delivery
1
Upper part of remote control
2
Base for wall-mounting
3
Slide cover
4
Installation and operating instructions
2.3 Supplementary accessories
See also the pricelist.
•
IPM 2
: module for control of up to two mixed
heating zones. Control of one unmixed
heating zone in the heating system possible.
2.4 Cleaning
B
If necessary, use a damp cloth to wipe the
controls housing. Never use aggressive or
acidic cleaning agents for this.
The FB 100 can only be connected
to systems with FW 200 and a boiler
with BUS-enabled Heatronic 3.
Dimensions
Rated voltage
10...24 VDC
Rated power
(excluding illumination)
6 mA
Remote control output
2-wire BUS
Ambient temperature
32 ... +122 °F
(0 ... +50 °C)
Enclosure rating
III
Protection level
IP20
Tab. 1
Specifications
2
4
1
3
6 720 613 058-01.1R
8
