Bosch DIVAR DIP-7080-00N, Installation Manual

Page: 67 / 72

better performance than comparable systems. The X8SIL/X8SIL-F/X8SIL-V also features a TCO
timer (to enable the system to recover from a software/hardware lock), ECC Error Reporting,
Function Disable and Intruder Detect.
Intel 3400/3420 chipset features
–
Direct Media Interface (up 10 Gb/s transfer, Full Duplex)
– Intel Matrix Storage Technology and Intel Rapid Storage Technology
– Dual NAND Interface
– Intel I/O Virtualization (VT-d) Support
– Intel Trusted Execution Technology Support
– PCI Express 2.0 Interface (up to 5.0 GT/s)
– SATA Controller (up to 3G/s)
– Advanced Host Controller Interface (AHCI)
PC health monitoring
This section describes the PC health monitoring features of the X8SIL/X8SIL-F/X8SIL-V. These
features are supported by an onboard System Hardware Monitor chip.
Recovery from AC power loss
BIOS provides a setting for you to determine how the system will respond when AC power is
lost and then restored to the system. You can choose for the system to remain powered off (in
which case you must hit the power switch to turn it back on) or for it to automatically return
to a power on state. The default setting is Last State.
Onboard voltage monitoring
The onboard voltage monitor will scan the following voltages continuously: CPU core, +3.3V,
+5V, +/-12V, +3.3V Stdby, +5V Stdby, VBAT, HT, Memory, Chipset. Once a voltage becomes
unstable, it will give a warning or send an error message to the screen. Users can adjust the
voltage thresholds to define the sensitivity of the voltage monitor by using SD III.
Fan status monitor with software
PC health monitoring can check the RPM status of the cooling fans via Supero Doctor III.
CPU overheat LED and control
This feature is available when the user enables the CPU overheat warning feature in the BIOS.
This allows the user to define an overheat temperature. When this temperature reaches this
pre-defined overheat threshold, the CPU thermal trip feature will be activated and it will send
a signal to the buzzer and, at the same time, the CPU speed will be decreased.
Power configuration settings
This section describes the features of your motherboard that deal with power and power
settings.
Slow blinking LED for suspend-state indicator
When the CPU goes into a suspend state, the chassis power LED will start blinking to indicate
that the CPU is in the suspend mode. When the user presses any key, the CPU will wake-up
and the LED indicator will automatically stop blinking and remain on.
BIOS support for USB keyboard
If the USB keyboard is the only keyboard in the system, it will function like a normal keyboard
during system boot-up.
Main switch override mechanism
When an ATX power supply is used, the power button can function as a system suspend
button. When the user presses the power button, the system will enter a SoftOff state. The
monitor will be suspended and the hard drive will spin down. Pressing the power button again
to wake-up the whole system. During the SoftOff state, the ATX power supply provides power
8.3
8.4
DIVAR IP 7000 2U Appendices | en 67
Bosch Sicherheitssysteme GmbH Installation Manual 2013.09 | V2 | DOC