Carephone 62
Programming | en
31
TeleAlarm
User Manual
F.01U.141.162 | V6 | 2015.04
63 Acoustical feedback for technical failures
The Carephone 62 can be set to announce technical failures through the
LED lamps and the loudspeaker, or through the LED lamps only.
–
0
= loudspeaker off
–
1
= loudspeaker on
–
2
= loudspeaker on from 7:00 to 21:00
–
3
= an acoustical failure indication (message or beep) shall be
repeated with a pause of 10 seconds until the Action button is
pressed.
–
4
= an acoustical failure indication (message or beep) shall be
repeated during day time (from 7:00 to 21:00) with a pause of 10
seconds until the Action button is pressed.
Settings
2
and
4
are only available if the time and date are set. This can be
done through keyboard programming, Configuration Manager with serial
connection or via a remote date/time update from a receiver.
70 Automatic test call interval
You can program the interval between automatic test calls from the
Carephone 62 to the monitoring centre in days. In addition, there is a test
call after power up or leaving programming mode, as well as a test call per
randomization.
–
Select from
1
to
28
days.
–
0
= off
–
Default value is
0
.
71 Action button (S button)
The Action button can be configured differently according to your needs:
–
0
= off
–
1
= service button / direct call (e.g. service call to a monitoring centre
or direct call to a relative)
–
3
= activate relay output (e.g. a door opener)
–
4
= send a manual test call (by pressing at least 2 seconds on the
action button)
–
Default value is
0
.
