38
en | Programming
Carephone 62
F.01U.141.162 | V6 | 2015.04
User Manual
TeleAlarm
–
The Carephone 62 announces
"setup B"
and announces
the date and time value in the format DD MM YYYY HH MM
as a list of digits.
–
Enter the value of the date and time in the above format,
using keys
0
to
9
. As soon as 12 digits are entered, the unit
determines if the date & time are valid. Do not press
C
.
–
The unit plays a sound if the input is valid or announces
"failure"
if it is incorrect. If incorrect, type it again.
–
Exit the date and time programming mode by pressing
*
.
6.3
Test mode
Pressing the wireless transmitter or the emergency call button
generates an acoustical signal without starting an alarm.
Enter test mode
–
Press
P
and
A
together for at least one second.
–
The Carephone 62 announces
"test"
.
–
Press
9, 0
and
C
.
During 3 minutes, the
red lamp
flashes every two seconds and
the Carephone 62 emits a
short beep
every five seconds.
–
Press the button of a registered wireless transmitter.
–
When the Carephone 62 receives the signal from a
registered wireless transmitter, it emits a
long beep
.
NOTICE!
If your Carephone 62 is reset or experiences a power down, the
date and time are reset to the default value
270520091830
. In
this case, the following functions are disabled:
–
activity monitor in setting 99 (
see step 40
)
–
acoustical feedback in settings 2 and 4 (
see step 63
)
–
RF activation start and end time (
see steps 121, 122, etc
)
This is valid until the Carephone 62 sends an alarm to a
monitoring center, allowing to set date and time remotely.
NOTICE!
Every time the Carephone 62 receives a signal from a registered
wireless transmitter, the three-minute time frame is reset.
If no signal is received, the Carephone 62 returns to standby.
