36
en | Programming
Carephone 62
F.01U.141.162 | V6 | 2015.04
User Manual
TeleAlarm
6.2.5
Special key functions
Restore the programming steps to the factory settings
–
Press
P
and
R
together for at least two seconds.
–
The unit announces:
"Setup reset"
.
The unit is now ready for language selection.
Reset the Carephone 62
–
Press
R
for at least one second.
The unit emits a beep and the unit reboots.
Easy wireless transmitter registering with top-cover installed
–
Press buttons
<Yellow> <Green>
together for at least two
seconds.
–
The unit waits for a wireless signal.
–
Press the button of the wireless transmitter.
–
The unit acknowledges with a beep.
–
Press the button of the
same
transmitter to confirm.
–
The unit acknowledges with two beeps.
The code number of the wireless transmitter is registered in
Selection 91
(erasing the previous code number).
91-99 & 90 Registering wireless transmitters
Up to 10 wireless transmitters or detectors can be registered directly on
the keyboard with a code number contained in the transmitter itself. These
code numbers must be stored in the Carephone 62. To register a wireless
transmitter:
a.
Select programming step 91.
b.
The Carephone 62 announces:
"Selection 91 is..."
c.
Press the button of the corresponding wireless transmitter.
d.
The Carephone 62 announces:
"Selection 91 is..."
e.
Press
C
to confirm. The wireless transmitter is now stored.
Restoring the factory settings deletes all registered wireless transmitters.
Programming the next 10 wireless transmitters (11 to 20) can be done
only with the Configuration Manager or Alarm Management Systems.
CAUTION!
This function deletes all user settings and restores the factory
settings instead!
