AutoDome Junior HD
Installing a Recessed Mount | en
51
Bosch Security Systems, Inc.
Installation Manual
F.01U.275.803 | 6.0 | 2012.11
6.2.3
Installing the Camera to the Mounting Plate
To install the base to a surface or suspended ceiling using the
supplied mounting plate, do the following:
1.
Loosen the single safety locking screw on the base of the
unit using the user-supplied T-10 Torx wrench.
Figure 6.5
Unlock Safety Locking Screw
2.
Remove the screw from the Earth ground (
)on the top
of the mounting bracket.
3.
Attach a user-supplied ground wire to the Earth ground
(
) screw hole on the mounting bracket and secure with
the screw.
4.
Attach the green grounding wire from the unit to the
grounded (
) screw hole on the mounting bracket using
the attached captive screw washer.
5.
Route wires on the side of mounting plate with the
crescent shaped cut-out.
NOTICE!
If you need to install the VJR-A3-SP Support Bracket, refer to
the guide included with the bracket. Once the bracket is
installed, continue with the next section.
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.
