36
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
AUTODOME inteox 7000i - 2MP (pendant)
2020-07 | 1.0 |
Installation Manual (pendant)
Bosch Security Systems
a
b
Figure 9.12:
Attach Pendant to Arm
1
Tilt up.
2
Hook and drop.
2a
Recessed Hinge Pin
2b Dome Connector
3
Rotate down to engage dome connector.
4
Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs).
2.
Drop the dome housing down slightly to engage the dome housing hook on the Pendant
Arm hinge pin, allowing the dome to rotate around the pin.
3.
Rotate the dome housing down to a vertical position and gently push upward to engage
the connector on top of the dome housing.
!
Caution!
If you feel any resistance when rotating the dome housing or when engaging the connector,
stop immediately and start over.
4.
Hold the Pendant housing in position while tightening the two (2) 5-mm Allen head
mounting screws on top of the housing to
10-12 N-m (90-105 in.-lbs)
.
!
Caution!
You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90‑105 in.-lbs)
to ensure a proper seal between the arm and the housing.
Summary of Contents for AUTODOME inteox 7000i 2MP
Page 1: ...AUTODOME inteox 7000i 2MP pendant en Installation Manual pendant ...
Page 2: ......
Page 65: ......