AUTODOME inteox 7000i - 2MP (pendant)
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
35
Bosch Security Systems
Installation Manual (pendant)
2020-07 | 1.0 |
5.
Attach the grounding spade from the 5-pin mating connector to the other spade terminal
inside the mounting plate.
6.
Attach the 5-pin Power In mating connector to the 24 VAC Power cable (cable 2)
connected to the pendant.
7.
Remove the mating connector from the Relay Contacts cable (cable 3).
8.
Connect the incoming relay contact wires to the mating connector. Then, reattach the
mating connector to the Relay Contacts cable.
9.
Attach an RJ45 plug to the incoming UTP cable.
10. Connect the incoming RJ45 video connector, installed previously, to the UTP Video/
Ethernet cable (cable 5).
11. Connect the outgoing alarm wires to the flying leads coming from the 4-pin Alarm Outputs
cable (cable 6).
12. Connect the incoming alarms wires to the flying leads coming from the 6-pin Alarm Inputs
cable (cable 7).
13. Connect the incoming serial communication wires to the 6-pin mating connector supplied
with the VGA-PEND-WPLATE kit. Refer to the Power Supply Box Connections table above
for details.
14. Attach the 6-pin serial communication mating connector to the Serial Communications
cable (cable 8).
15. Connect the Earth ground wire, if available, to the crimp ring terminal inside the
Mounting Plate.
Note
: The Earth ground is not provided with the VGA-PEND-WPLATE kit; it is a ground
connection made at the installed location.
16. After making the harness connections to the Mounting Plate, rotate the Pendant Arm to
close and tighten the two (2) captive screws to 10‑12 N-m (90-105 in.-lbs).
Notice!
After all wiring is complete, close the cover door and tighten the two (2) captive screws on
the cover door to 10-12 N-m (90-105 in.-lbs).
9.7
Attach Pendant to Arm and Tighten
Notice!
Before attaching the AUTODOME Pendant, visually inspect the dome and arm connectors for
any blocked pin holes or bent pins.
1.
Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,
located on top of the dome housing, over the recessed hinge pin of the arm.
Summary of Contents for AUTODOME inteox 7000i 2MP
Page 1: ...AUTODOME inteox 7000i 2MP pendant en Installation Manual pendant ...
Page 2: ......
Page 65: ......