AUTODOME inteox 7000i - 2MP (pendant)
Replacing a Pendant Bubble | en
51
Bosch Security Systems
Installation Manual (pendant)
2020-07 | 1.0 |
12
Replacing a Pendant Bubble
1. Using both hands, apply a firm counterclockwise (looking up at the dome) rotational force
on the pendant bubble assembly to set the bubble latch.
2. Insert a small (2 mm) straight blade screw driver into the release opening in the bubble trim
ring to release the lock, and then remove the screwdriver.
Figure 12.1:
Pendant Bubble Release Opening
3. Firmly rotate the bubble counterclockwise approximately 20 degrees until the bubble
assembly releases from the pendant housing.
4. Locate the four tabs (item 1, below) inside the trim ring that attach the trim ring to the
bubble.
5. Gently push each tab out and down (away from the bubble) to disengage the tabs.
6. Remove the bubble from the trim ring.
7. Insert the replacement bubble inside the trim ring and align the release tab (item 2, above)
on the trim ring with the release slot on the bubble.
8. Clean the bubble according to the instructions in the section “Maintenance.”
9. Insert the replacement bubble and trim ring assembly into the pendant housing, and rotate
it clockwise until it locks. The latch mechanism makes a click when locks.
Summary of Contents for AUTODOME inteox 7000i 2MP
Page 1: ...AUTODOME inteox 7000i 2MP pendant en Installation Manual pendant ...
Page 2: ......
Page 65: ......
