Pack201 | Preface | Section 1
EN | 7
© Bosch Packaging Technology, Inc.
All rights reserved 2012
1.4 Installation
DANGER
Although the design of this equipment
incorporates safeguards to protect
operating and maintenance personnel,
care must always be used when
operating, adjusting, and/or servicing� If
extreme care is not taken, a very serious
or fatal injury may result�
Remove the wrapper from the shipping crate and
check it carefully for any damage� If damaged, notify
the carrier immediately to file a claim. Contact Bosch
for further instructions if the damage is extensive�
Make sure all items that are listed on the packing slip
are received� Remove all packing material, chips, nails
etc� from the equipment�
1.4.1 Place the Equipment
The wrapper is shipped with crossbars for moving and
positioning� To lift the machine off of the pallet using
a fork lift, bolt the crossbars under the main section of
the frame� Position the forks under the crossbars, not
directly under the machine frame�
Check all access ways, from the shipping and receiving
dock to the installation location to ensure that they are
wide enough for the machine to pass through�
Move the wrapper and all related equipment to the
production area�
DANGER
When lifting, be sure to use a lifting de-
vice rated to handle the machine’s weight
(approximately 4,000 pounds without the
infeed)�
Align the machine with the upstream and downstream
equipment and place the wrapper� Level the wrapper
by using a wrench on the flats of the adjusting legs to
turn the legs� If equipped with optional casters, make
sure that the casters are not touching the floor; the
wrapper must rest only on the adjusting legs� Remove
the crossbars�
If the Infeed conveyor was detached for shipping or
there is an automatic feeder, position and attach to
the wrapper’s receiving conveyor plate� After attach-
ing, level the infeed conveyor with the adjusting legs
as with those on the wrapper�
