English–
29
Bosch eBike Systems
0 276 001 SPUen | (23.4.14)
Charging the Battery on the Bike
Switch the battery off. Clean the cover of the charge socket
C7
. In particular, prevent the charge socket and the con-
tacts from getting dirty, e.g., with sand or soil. Lift the cover
of the charge socket
C7
and plug the charge connector
C5
into the charge socket
C6
.
Charge the battery only in accordance with all safety
instructions.
If this is not possible, remove the battery
from the holder and charge it in a more suitable location.
When doing so, read and follow the operating instruc-
tions for the battery.
Charging Procedure
The charging procedure begins as soon as the charger is
connected to the battery or the charge socket on the bike
and the main power supply.
Notice:
The charging procedure is only possible when the
temperature of the battery pack is within the permissible
charging temperature range.
Notice:
The drive unit is deactivated during the charging
procedure.
The battery can be charged with or without the display unit.
When charging without the display unit, the charging pro-
cedure can only be observed on the battery charge-control
indicator.
When the display unit is connected, the backlighting for the
display is switched on at low intensity and
“Charging”
ap-
pears in the text display.
The display unit can be removed during the charging proce-
dure, or it can also be attached after the charging proce-
dure has begun.
The charging state is displayed by the battery charge-con-
trol indicator
A3
on the battery and by the bars on the dis-
play unit.
When charging the main battery on the bike, the battery for
the display unit can also be charged.
During the charging procedure, the LEDs for charge-control
indicator
A3
on the battery pack light up. Each continuous-
ly lit LED is equivalent to a charge capacity of approx. 20 %.
The flashing LED indicates the charging of the next 20 %.
Use caution when touching the charger during the
charging procedure. Wear protective gloves.
Espe-
cially in high ambient temperatures, the charger can
heat up considerably.
Once the battery is fully charged, the LEDs extinguish im-
mediately and the display unit is switched off. The charging
procedure is terminated. The charging state can be dis-
played for 3 seconds by pressing the On/Off button
A4
.
Disconnect the charger from the main power supply and
the battery pack from the charger.
When disconnecting the battery pack from the charger, the
battery pack is automatically switched off.
Notice:
If you have charged on the bike, carefully close the
charge socket
C6
with the cover
C7
after the charging pro-
cedure so that no dirt or water can get in.
If the charger is not disconnected from the battery after
charging, after a few hours the charger will switch itself
back on, check the charging state of the battery and begin
the charging procedure again if necessary.
C5
C5
A2
A8
C7
C7
C6
C6
