English–
25
Bosch eBike Systems
0 276 001 SPUen | (23.4.14)
Operation
Initial Operation
Use only original Bosch battery packs approved for
your eBike by the manufacturer and purchased from
a trusted source.
Use of non-approved or counterfeit
battery packs can lead to death or serious injury.
Switching On and Off
Switching the battery pack on is one of the ways of starting
the eBike system. Read and follow the operating instruc-
tions for the drive unit and the display unit.
Before switching on the battery pack or the eBike system,
check that the lock
A6
is locked.
To
switch on
the battery pack, press the On/Off button
A4
.
The LEDs for indicator
A3
light up and, at the same time, in-
dicate the charge condition.
Always check that the battery pack is locked in
place.
To do this, pull on the battery pack handle (after
the key has been removed).
Notice:
When the battery pack capacity is below 5 %, none
of the LEDs for charge-control indicator
A3
will light up. On-
ly the display unit will indicate if the eBike system is
switched on.
To
switch off
the battery pack, press the On/Off button
A4
again. The LEDs for indicator
A3
go out. This also switches
off the eBike system.
When no power output from the eBike drive unit is request-
ed for approx. 10 minutes (e. g., because the eBike is
parked) and no button for the drive display unit or operat-
ing unit is pressed, then the eBike system, and thus the bat-
tery pack, automatically switches off to save energy.
The battery pack is protected against deep discharging,
overcharging, overheating and short-circuiting by the
“Electronic Cell Protection (ECP)”. In case of hazardous sit-
uations, a protective circuit automatically switches off the
battery pack.
When a defect in the battery pack is de-
tected, two LEDs for the charge-control
indicator
A3
flash. In this case, please
contact an authorized Bosch eBike
dealer.
