43
SM_150707_A
Service Manual IDYLLE since year 2014
12
13
11
Put a drop of Loctite on the first thread of the nut.
Slide the nut on the shaft.
Place back the lock ring in the groove where you found it.
Mount the piston, then screw it while holding the counter nut.
Tool(s) required :
-
16mm open ends wrench
-
14mm open ends wrench
-
Loctite 243
No torque – tighten to contact
Screw the nut on the shaft until the end of the thread, do not tighten.
Screw the cartridge cap, tighten by hand.
Hold the cartridge cap with the 32mm open end wrench.
Screw the nut against the cartridge cap with the torque wrench.
Tool(s) required :
-
32mm open end wrench
-
13mm open end socket
-
Torque wrench
Torque = 7Nm
Degrease and dry clean the threads with isopropyl alcohol and a rag.
Insert the compression bloc in the cartridge, then apply vegetal grease on the
stack-up through the hole.
Tool(s) required :
-
Spray of isopropyl alcohol
-
Rag
-
Vegetal grease (white)
1
1
2
3
2
3
4
1
2
3
4
