EN
130
Installation
www.bora.com
10.6.4 Inserting the cooktop
5
4
3
2
1
Fig. 10.12
Inserting the cooktop
[1]
Cooktop
[2]
Inlet opening
[3]
Air inlet nozzle
[4]
Stainless steel grease filter
[5]
Worktop cut-out
X
Before inserting the cooktop, remove the air inlet
nozzle [3] and the stainless steel grease filter [4].
X
Use the inlet opening [2] as a handle during
insertion.
X
Keep the cooktop [1] straight as you lift it into the
worktop cut-out [5]
X
Insert the cooktop [1] into the centre of the
worktop cut-out [5].
X
Precisely align the cooktop.
1
2
3
Fig. 10.13
Securing the cooktop in the middle
Adjusting the back panel of the unit
X
Before installation, check the suitability of the
floor unit with regard to the necessary installation
dimensions for the appliance and the planned
duct system.
X
If necessary, adjust the position of the back panel
according to the required installation dimensions.
10.6.3 Preparing the cooktop
Attaching the sealing tape
2
1
Fig. 10.10
Sealing tape in the case of surface
mounting
1
2
Fig. 10.11
Sealing tape in the case of flush
installation
[1]
Black, heat-resistant silicone sealant
[2]
Sealing tape
X
In the case of surface mounting, attach the
enclosed sealing tape [2] around the outer edges
of the underside of the cooktop. Do not leave any
gaps.
X
In the case of flush installation, attach the
sealing tape [2] to the horizontal cutting edge in
the worktop cut-out, even if you are sealing the
cooktop with a silicone sealing compound [1] or
similar.
