19
Machine Adjustment Procedures (Cont.)
Setting the height of the handle shaft (Cont.)
5)
Put the machine backward so that it rests on the
tilt support.
6)
Loosen the nut that holds the control rod against the slewing
bracket using a wrench.
7)
Thread up the control rod to the corresponding
level, tighten the nut, put together the control
rods, and tighten the slewing bracket.
8)
Lift up the control lever.
Changing the sanding drum
If the sanding drum needs to be removed for cleaning or replacement, then do the following:
1)
Put the machine backward so that it rests on the
tilt support and handle.
2)
Put down the belt protector.
3)
Lock the sanding drum by pushing the steel
pin into the hole in the pulley and into the
corresponding hole in the machine frame.
4)
Remove the sanding belt.