10
bona.com
Bona Belt Manual
Commencing Operation (Cont.)
Instructions for assembly (cont.)
1)
Grab hold of the motor's carry handle. Place the motor on the
machine frame and fasten the motor's hinge in the rear holder.
2)
Roll on and tighten the driving belt using the eccentric tightener. Lift
up the belt protector. Mount the dust pipe with the dust bag in the
pipe holder.
Excessive belt tension may cause the premature failure of the ball bearings.
Using the machine when not fully assembled may cause injury or damage to people or objects.
DO NOT
use the machine when it is not fully assembled. Keep all fittings tightly closed. Maintain machine settings in
accordance with the specifications.
If the machine has been disassembled before transport then assemble the motor as follows:
Dismantling the machine
1)
The machine can be taken apart into four parts
for transport.
2)
Put down the belt protector.
3)
Reduce the tension on the driving belt by
loosening the eccentric tightener.
4)
Roll off the driving belts.
5)
Hold onto the motor handle and lift up the motor
from the rear motor bracket.
6)
Push the control lever forward and down.
7)
Pull up the sliding sleeve.
8)
Loosen the locking wheel and pull up the handle shaft.
9)
Lift up the dust bag together with the dust pipe
upward until it loosens from the pipe holder.
10)
Carry the machine frame by holding the handle and the tilt support.
