BOMBARDIER rally 200, Operator'S Manual

Page: 93 / 130

1
V06C2FZ
1. Cooling drain plug
Unscrew the bleeding screw on the
top of thermostat housing.
V06C06Y
1
1. Bleeding screw
Drain the system completely and rein-
stall the drain plug.
Pinch hose between radiator and ther-
mostat housing with a large hose
pincher (P/N 529 032 500).
V06C07Y
Lift the front of vehicle high enough to
have front wheels off the ground.
Fill the radiator until the coolant comes
out by the thermostat housing bleed-
ing hole. Install the bleeding screw
then remove the hose pincher.
NOTE:
If no coolant comes out by the
bleeding hole, squeeze the lower ra-
diator hose several times until coolant
comes out.
Complete the radiator filling.
Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator
cap off. Slowly add additional coolant
if necessary.
At this point, wait until engine reaches
normal operating temperature.
De-
press the throttle lever two or three
times; then add coolant if required.
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.
Check if the carburetor heater is
warm. If not, redo the bleeding pro-
cedure.
Reinstall front facia.
Drive Belt
See an authorized Bombardier ATV
dealer to inspect and/or replace the
drive belt.
92
______________________