BOMBARDIER rally 200, Operator'S Manual

Page: 101 / 130

V06H06Y
Turn the axle forward to increase or
backwards to decrease chain free play.
Tighten the chain tensioner lock bolts
to 48 N•m (35 lbf•ft).
CAUTION:
Never operate this vehi-
cle with the drive chain too loose or
too tight as severe damage to the
drive components can occur.
When the adjustment is done, repeat
the above procedure to check the
deflection several times at different
spots on the chain.
Replacement
With the chain installed on vehicle,
measure the distance between a span
of 13 links from pin center to pin cen-
ter. Change drive chain if the distance
exceeds the service limit, see an au-
thorized Bombardier ATV dealer.
V02H01Y
A
A. 404 mm (15-29/32 in)
Drive Chain Slider
Check the drive chain slider at every
ride.
Replace the drive chain slider when it
is worn.
See an authorized Bombardier ATV
dealer for replacement.
Sprocket and Pinion
Check the sprocket axle and pinion
for distortion, excessive wear or other
damages.
V02H02Y
1
2
1. Good
2. Replace
CAUTION:
Replace chain, sprocket
axle and pinion together to prevent
rapid chain and sprocket wear. In-
stall a new retaining ring each time
the pinion is removed.
NOTE:
The drive pinion must be in-
stalled with the lip toward the outside
of vehicle.
Wheel
Occasionally, wheel nuts should be
removed to apply anti-seize lubricant
on studs to ease future removal. This
is particularly important when vehicle
is used in salt-water environment or
in mud. Remove one nut at a time,
lubricate then retorque to 70 N•m
(52 lbf•ft).
Wheel Bearing/Bushings
Condition
Push and pull the wheels from the
upper edge to feel the play. See an
authorized Bombardier ATV dealer if
there is any play.
100
_____________________